June 3, 2013

Exhaust repair and custom tool

In among working with mannequins we had a chance to do an exhaust repair and have a custom tool built.  The exhaust repair was pretty straight forward, it was a crack that propagated around the merge of a stainless steel system.  The quick and simple way would be to run a bead over it…however the chances of it cracking are still there since the quality of the original weld is under question hidden under a nice TIG weld.  Not good.  So instead we grind the weld out all the way around, then run two passes around the collector with some filler material to make it strong.

The crack was more apparent on the other side of this part.

stainless steel exhaust crack repair

Once the weld is ground out the surface around the weld has to be cleaned and prepped prior to welding.  After that process the inside of the tubing has to be back purged with argo and then it’s ready to weld.  Here it is all welded up and ready to go.

stainless steel crack repaired

 

Here’s the custom tool that we made for another customer.  Two 304 SS plates with a bolt and pipe passing through them.  The bolt and pipe are welded to the smaller diameter plate, this allows the larger plate to be torqued down and expand the rubber gasket to seal the assembly in the pipe.  The pipe is then connected to a manometer or similar pressure gauge to monitor pressure in a piping system.  Perpendicularity of the bolt and pipe are important, otherwise binding would occur when torquing or disassembling the part.

pipe pressure tool